Photo by IPS. Exterior of the AC3S-G2, at the wild land fire exercise in Woodside, CA, 2007.

Photo by IPS. The AC3S-G2 at a wireless communications exercise for the Livermore, CA school District, 2007.

• Configured for 1-3 persons in operations desk area
• RF6101 single axel, 10' box, 14' overall cubic foot capacity, AVG payload capacity 2500 pounds
• Interior dome lighting and lighting controls
• Fifteen 115 VAC receptacles; receptacle for 115 VAC from external source
• 3500 watt generator (gasoline), located on the hitch A frame
• Roof mount for VSAT terminal
• Roof mounted radio antennas (as designed for the IC4U)
• Roof mount 7700 BTU air conditioner with 5600 BTU heater with thermostat controlled climate control
• Combination printer, scanner, copier, and fax machine
• Microwave, refrigerator/freezer, coffee maker
• Vehicle not included
  

Satellite Reach-Back

• 0.75m self-acquiring antenna
• 2 watt block up converter
• Ku Band PLL low noise block converter
• VSAT satellite receiver

Radio Communication & Interoperability

• Equipment rack with adequate electrical outlets
• Radio interoperability gateway
• 32 key hardware panel
• 17" touch screen monitor
• Two DSP-RIB radio interface modules
• GPIO input/output module
• Miscellaneous interconnect cables
• Laptop for use with radio programming
• IPS Interoperable Radio IP capability, 8 radio chassis with UPS and battery with charger
• 2U tray for two additional radios
• Programming software for radios
• Handheld frequency analyzer for identifying unknown radio frequencies
• Radio antennas, mounting hardware, and cables

Streaming Video Capture

• Mast mounted day/night camera
• Controller for camera
• Video server with 2 channel video encoder
• Matrix 8 x 8 video switch panel
• 19" flat panel monitor with analog video and VGA switchable outputs